Finned heaters are widely used in life
The Finned heater is mainly used to heat the required air flow from the initial temperature to the required air temperature, up to 850 ° C. Has been widely used in aerospace, weapon industry, chemical industry and universities and other scientific research and production laboratories. Especially suitable for automatic temperature control and large flow high temperature combined system and accessories test. The air duct type electric heater is composed of two parts: the body and the control system. The heating element is made of stainless steel steel tube as a protective sleeve, high temperature resistance alloy wire, crystalline magnesium oxide powder, and formed by compression process. The control part uses advanced digital circuits and integrated circuits. The trigger, high back pressure thyristor and other components form an adjustable temperature measurement and constant temperature system to ensure the normal operation of the Finned heater.
The Finned heater of the chimney duct plays a significant role in life and production. Its appearance has greatly saved the cost and consumption in the process of electric heating and has a good auxiliary effect on production and life. With the development of the electric power industry and the introduction of new technologies, the original hydraulic ash removal was changed to dry ash removal in thermal power plants, which not only saved a lot of water resources, grain fields, but also contributed coal ash to humanity. Finned heaters can use coal ash to make cement, coal ash bricks, and build highways, while also improving environmental pollution for the benefit of the people. Finned heater is a new type of heating equipment specially used for ash removal system of coal-fired power plants. . The device consists of two parts: the Finned heater body and the control system. The control part adopts advanced digital circuits, integrated circuit triggers, high back pressure thyristors, etc. to form an adjustable temperature measurement and constant temperature system to ensure the normal operation of the Finned heater. The heating element uses a straight tube instead of a U-shaped structure, and a special sheet hand can be used for easy installation and removal.
